Notifications
Clear all

Prusa Slicer Ooze Sheild  

  RSS
mena_samir
(@mena_samir)
Membre
Prusa Slicer Ooze Sheild

Hello,

I am using PrusaSlicer to print parts with 2 extruders. I used another slicer before and was working well with an ooze sheild made from only one of the two extruders. I know there is a DraftSheild that I can use in Prusa, but I can't tell Prusa to make that draft sheild with only the extruder #2 for example. Also, it is not really an ooze sheild, because it goes up the whole print and doesn't stop at the point where one extruder stoped printing. Is there really no setting for an ooze sheild in prusa like the other slicers?

Publié : 03/07/2024 4:06 pm
Partager :