Notifications
Clear all
Prusa 2.9.4 and QIDI Plus 4
I was just wondering where I can set the chamber venting fan (the one with carbon filtering). I used to have it going full blast when using Orca slicer, but alas.... Orca has started crashing on me so I switched to Prusa which runs fine and it prints fine. I just cannot get the exhaust fan going the way I want it to. Orca has a specific setting for it, but I can't find it in Prusa Slicer. Does anyone know if and if so where it is and what it is called?
Posted : 25/02/2026 8:51 pm