RE: Profile for Anycubic Kobra ?
Were you able to figure it out? Thanks
RE:
Hello everyone,
the topic might be old, but I had the same problem a few days ago. I've been working with Cura for years and it yielded great result with my old ender 3, but recently i bought a used kobra (ver. 1) and the prints were okay, but not quite there. I wanted to start with the PrusaSlicer, but there was no profile for the kobra. Then I logically thought, that AnycubicSlicer (based on Prusa) would support my new printer, which it also didn't.
The solution was very simple indeed. I just opted for the Kobra 2 profile in the AnycubicSlicer. I just wanted to give it a go, since I didn't think the two printers would be so much different.
AND IT WORKED BEAUTIFULLY!!!
So, basically what you'll do is install anycubic slicer and choose kobra 2 as your printer. Make sure to go directly to the settings and change the assigned speeds, so your kobra doesn't fly apart 😀
That's it!!!
I've tested this on multiple long, big prints so far and I can say I never had such good results with Cura (I'm pretty experienced in Cura).
Hope this works for you too!