Printing Support Interface Layer From a Different Material

Dernier message

RSS

Tom De Winter

(@tom-de-winter)

Estimable Member

Printing Support Interface Layer From a Different Material

I have a MK4 / MMU3. I’d like to print the support interface layer from PLA if the main object is PETG (or vice versa). This is to facilitate a clean and easy breakaway of the support material from the main object.

How do I do this using the Prusa slicer?

Thanks,

Tom

Publié : 28/01/2026 1:59 am

FoxRun3D

(@foxrun3d)

Illustrious Member

RE: Printing Support Interface Layer From a Different Material

Same answer as to your previous post: https://forum.prusa3d.com/forum/postid/780026/

Formerly known on this forum as @fuchsr -- https://foxrun3d.com/

Publié : 28/01/2026 2:32 pm

Statistiques du forum

595 Forums

70.3 K Sujets

491.7 K Messages

15 En-ligne

81.5 K Membres

Le dernier des messages: odd vertical imperfection - bending outward layer (Prusa CORE One) Notre nouveau membre: Tocri77 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé