Avisos
Vaciar todo
Printing a part with a bunch of small holes, can't get a good result.
I've had a request to print this part:
However, it constantly fails to print because of the small holes. It tries to place all of the circles individually, but the amount of retractions messes up the print.
I use the standard profile (0.2 quality in this case) and this time I added a raft and activated "Only retract when crossing perimeters", but since the holes are perimeters, that doesn't change much.
Are there any settings that would help me print this better?
Edit: I use a MK3s with polymaker lite filament.
Este debate ha sido modificado el hace 12 months por RikH
Respondido : 04/12/2023 9:24 am