Notifications
Clear all
Pause (M601) not pausing
My setup is Prusa Slicer 2.60 --> Octoprint 1.9.1 --> Prusa Mini 4.4.1
I would like to pause some prints for magnet insertion, but it blows right by the pause point. Filament color changes work fine, but I am about to do a ton of printing, so I don't want to waste that much filament each time.
It didn't work on earlier versions either, but I just used color change.
My pause G-code is just M601. Looks like it was a problem with firmware support in the past through Octoprint. But honestly that was years ago.
Opublikowany : 01/07/2023 7:41 pm