Over-Extrusion of highest layer  

RE: Over-Extrusion of highest layer

Awesome. Switched to PrusaSlicer. Having Fun using all features but can't get basic print done.

Top layer and all gaps fill are overextruding massively. I see that everyone has it's way to tune their printers with guides and sanding but @korbyn has asked a specific question here. 

Prusa slice everything fine except TOP layer. There is no way to tune Top flow. And looks like none here tried any other slicer. 

Print basically awful. Any way to fix that? Will add comparison protos later(Same printer, Cura vs Prusa). 

And NO, I should not calibrate anything as long as 2 different slicers has flow set 100% providing such different results. That's a Prusa`s issue unless some settings could help.

RE: Over-Extrusion of highest layer

All flow settings are 100% for both slicers.
Is there any specific things i can to change except tuning flow rate(Cura) and Extrusion Multiplier(Prusa) for good visual results?

Cura

Prusa