Notifications
Clear all
Page 2 / 2
Précédent
Topic starter
answered:
RE: Over Extrusion issue (help)
Its sorted!
I've changed the extrusion width to .45mm, re-calibrated the extrusion multiplier and i'm now printing a cube with 100% infill and its going perfectly, no scrapping or signs of over extrusion.
Thanks Area51 and everyone else for your input. It's very much appreciated.
Publié : 20/12/2020 1:50 pm
RE: Over Extrusion issue (help)
@grimmy579
I'm happy to hear that!
Just curious, how much did you have to correct the multiplier to get the 0.45mm calibration correct?
Have a look at my models on Printables.com 😉
Publié : 20/12/2020 2:17 pm
Topic starter
answered:
RE: Over Extrusion issue (help)
@area51
It’s gone from 1 to .89 with this PLA+
thanks again
Publié : 20/12/2020 7:03 pm
RE: Over Extrusion issue (help)
That is the same as removing 12% over extrusion...
Have a look at my models on Printables.com 😉
Publié : 21/12/2020 12:06 am
Topic starter
answered:
RE: Over Extrusion issue (help)
@area51
Is it. I can’t get my head around why reducing the extrusion width made it over extrude 😂 it’s been perfect since though
Publié : 21/12/2020 8:22 pm
Page 2 / 2
Précédent