New 2.8 alpha/beta show empty sliced bed
Dont know is a bug or something on my side.
just add a cube on the plate, slice, the sliced plate is empty. the stats are shown, but nothing inside.
anyone have this problem?
Windows 7 x64
RE: New 2.8 alpha/beta show empty sliced bed
Hi, I have the same problem.
Did you find any solution?
Windows 10Pro x64
RE: New 2.8 alpha/beta show empty sliced bed
Same here, gone back to 2.7.4
RE: New 2.8 alpha/beta show empty sliced bed
iv'e reported on github, there was about 3 bug reports about this already.
the developers could not reproduce the error yet.
RE: New 2.8 alpha/beta show empty sliced bed
The problem appears to be on OpenGL, as using the --sw-renderer in commandline, the sliced part is properly shown
RE: New 2.8 alpha/beta show empty sliced bed
I returned the version to 2.7.4 with no chance of using 2.8.0
RE: New 2.8 alpha/beta show empty sliced bed
Hello Marlon, where do I add this insertion? --sw-renderer
RE: New 2.8 alpha/beta show empty sliced bed
create a shortcut to prusaslicer.exe, the on the shortcut properties, add " --sw-renderer" on the target (without quotes)