Avisos
Vaciar todo

Mitigate wall bulge  

Página 7 / 7
  RSS
Erlis Vidal
(@erlis-vidal)
Active Member
RE: Mitigate wall bulge

Just a quick update. The new feature Arachne  does a good job with this issue no doubt.

Yesterday I decided to give another look at SuperSlicer, I looked at it few years back, and well decided to give it a try in 2022. I'll have to say... wow

@rinkel, could you do a test print with SuperSlicer and see how it goes? It doesn't have Arachne as far as I know, but the print quality was way better

Respondido : 19/07/2022 1:10 pm
rinkel
(@rinkel)
Estimable Member
RE: Mitigate wall bulge

Downloading

Respondido : 19/07/2022 1:26 pm
rinkel
(@rinkel)
Estimable Member
RE:

@erlis-vidal

I just printed the box-bottom with SuperSlicer. It actually did a nice job.
I small line where the solid goes into the thinner walls, but much much better than PrusaSlicer v2.4.2

Not bad at all.

Respondido : 22/07/2022 8:29 pm
rinkel
(@rinkel)
Estimable Member
RE: Mitigate wall bulge

I actually think that that line is the same as the benchy-hull-line. Solid to non solid.

Respondido : 22/07/2022 8:41 pm
The German
(@the-german)
Active Member
RE:

What was your solution to the problem shown in your pictures on page 1? I have the same issue..

Esta publicación ha sido modificada el hace 3 months por The German
Respondido : 24/12/2023 2:00 pm
SujetRandom
(@sujetrandom)
Active Member
RE: Mitigate wall bulge

Hi ! 

try to put the same speed for internal perimeter and external perimeter. Like this in prusa slicer :

perimeter 40mm/s

external perimeter 40mm/s

small perimeter : 20 mm/s 

it works well for me 

have a good day ! 

Respondido : 26/12/2023 8:59 am
Página 7 / 7
Compartir: