Notifications
Clear all

Missing Features in MacOS?  

  RSS
Darkshoe
(@darkshoe)
New Member
Missing Features in MacOS?

I'm having some trouble locating some features in PrusaSlicer 2.3.0 on a MacOS 13.2.1 system. Hopefully I am making a mistake, but my searches have been fruitless.

  1. I can't locate the toggle for Arachne. I am slicing some small parts and noticed the Gap Infill was being used. I haven't seen Gap Infill since Arachne was released and thought this is strange.  I found a knowledge article and a forum post claiming the Arachne toggle in 2 different locations, neither of them were present for me (PrusaSlicer is already in Expert mode).
    Gap Infill
  2. I want to add a brim to only one of these small parts. Normally I do this by right-click > Add Settings, it is either in there or in Advanced, but I do not see it.
    No Brim 1
    No Brim 2

Best Answer by Crab:

You need  version 2.5 for those features..  get version 2.6 alpha 5 and you get tree supports and text.. You can add a different color icon so you can use both the alpha

and the released version. Click on image to see it all.

 

Publié : 10/04/2023 3:22 am
Crab
 Crab
(@crab)
Reputable Member
RE: Missing Features in MacOS?

You need  version 2.5 for those features..  get version 2.6 alpha 5 and you get tree supports and text.. You can add a different color icon so you can use both the alpha

and the released version. Click on image to see it all.

 

Publié : 10/04/2023 3:42 am
Darkshoe
(@darkshoe)
New Member
Topic starter answered:
RE: Missing Features in MacOS?

Thank you very much! Now I've downloaded and installed 2.5.2.

I had used "Check for Updates" from the Menu Bar and it said I was on the latest release. I tried again after reading your post (no updates available) and again after restarting (no updates available).

Publié : 10/04/2023 4:09 am
Partager :