Avisos
Vaciar todo
Low contrast text in GCODE preview mode
Hello, I am rather new to PrusaSlicer and wondering if or how it's possible to change the text color used on the layer slider (pictured below) when previewing the GCODE after slicing. It's a low contrast grey-on-grey and very difficult to read. I looked in preferences but could not find any relevant settings. Thank you in advance.
Respondido : 27/01/2024 2:10 am
RE: Low contrast text in GCODE preview mode
It's probably best to ask on the Prusa Slicer Git Hub Page, where the developers hang out.
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Respondido : 27/01/2024 9:16 am