Looking for G-Code for Ender 5 Plus
 
Notifiche
Cancella tutti

Looking for G-Code for Ender 5 Plus  

  RSS
delaney.a
(@delaney-a)
Active Member
Looking for G-Code for Ender 5 Plus

Looking for good start and stop G-Code (start and stop) for Ender 5 Plus with the BLTouch I heard there is a g29 code? Not sure 

Postato : 03/02/2022 4:11 pm
Cotharyus
(@cotharyus)
Active Member
RE: Looking for G-Code for Ender 5 Plus

There is an Ender 5 Plus profile in 2.4.0 - I'm running a Benchy on it right now that was sliced in the Prusa slicer. Profiles are a bit scarce - there is only one that I see, but it seems to work so far.

Postato : 04/02/2022 7:44 pm
Condividi: