Logo not ankered with multimaterial print
 
Avisos
Vaciar todo

[Resuelto] Logo not ankered with multimaterial print  

  RSS
Tobias
(@tobias-4)
Miembro
Logo not ankered with multimaterial print

Hi guys,

I tried to find a solution on the forum and internet but couldn't find anything. Maybe my english is too bad.

I'm trying to print a box on a Prusa XL with a Logo up front. 
I turned the logo to parts and assigned different extruders for the different colours. 

Now the problem is, that the logo is not ankered at all into the wall of the box so it will most likely just fall off. The parts overlap by some mm's though.

When painting the model instead of assigning different extruders, it gets ankered but looks bad. 

Is there a setting besides interface shells and overlap (no change)? If nothing works, I'll probably just print it flat and glue it, but that's not what I bought the XL for. 

Any help is much appreciated.

bb Tobias

Respondido : 03/07/2024 11:22 am
Tobias
(@tobias-4)
Miembro
Topic starter answered:
RE: Logo not ankered with multimaterial print

never mind, works fine if I switch from add part to add modifier

Respondido : 03/07/2024 2:00 pm
Diem
 Diem
(@diem)
Illustrious Member

Please save your project as a .3mf file

Files > Save Project as

Zip the .3mf and post it here. It will contain both your part and your settings for us to diagnose.

Cheerio,

Respondido : 03/07/2024 3:13 pm
Tobias
(@tobias-4)
Miembro
Topic starter answered:
RE: Logo not ankered with multimaterial print

As stated, problem disappears when switching from add part to add modifier. Thanks for your offering 😊 .

Respondido : 03/07/2024 4:08 pm
Compartir: