Lil help with top layers pls 🙂
 
Benachrichtigungen
Alles löschen

Lil help with top layers pls 🙂  

  RSS
LS MODS
(@ls-mods)
Mitglied
Lil help with top layers pls 🙂

Appols if this has already been asked.... had a qik search but wasnt sure of the right terminology.

Is there a way/setting to just print a clean top layer before the second colour pattern starts.

Cheers LS

 

 

Veröffentlicht : 30/06/2023 11:37 pm
Neophyl
(@neophyl)
Illustrious Member
RE: Lil help with top layers pls 🙂

At the moment there is  no setting in Prusa Slicer to control this.  Topfill is part so far under any features of the layer above.  

There are several issues already open on the Prusa Slicer github for example https://github.com/prusa3d/PrusaSlicer/issues/8818

Super Slicer (a fork of Prusa Slicer) has settings where this can be controlled, unfortunately the last Super Slicer stable release was some time ago and is based on Prusa Slicer 2.4 and it looks like the project is not being maintained anymore which is a pity.

Veröffentlicht : 01/07/2023 8:41 am
LS MODS
(@ls-mods)
Mitglied
Themenstarter answered:
RE: Lil help with top layers pls 🙂

 

Posted by: @neophyl

At the moment there is  no setting in Prusa Slicer to control this.  Topfill is part so far under any features of the layer above.  

There are several issues already open on the Prusa Slicer github for example https://github.com/prusa3d/PrusaSlicer/issues/8818

Super Slicer (a fork of Prusa Slicer) has settings where this can be controlled, unfortunately the last Super Slicer stable release was some time ago and is based on Prusa Slicer 2.4 and it looks like the project is not being maintained anymore which is a pity.

Cheers Neophyl tyvm mate 👍  i'll give SS a go 🙂

Veröffentlicht : 01/07/2023 9:47 pm
Teilen: