Legend calculated and displayed volumetric flow rates don't match
 
Notifiche
Cancella tutti

Legend calculated and displayed volumetric flow rates don't match  

  RSS
eewoz
(@eewoz)
Active Member
Legend calculated and displayed volumetric flow rates don't match

Using the Legend to display Layer Height, Layer Width, Speed, and Volumetric Flow Rate gives inconsistent results.  For a print that I am working on the Legend reports that Height is 0.56 mm, Width is .999 mm, Speed is 15 mm/sec, and Volumetric Flow Rate is 3.21 cubic mm/sec.  The literature says that Volumetric Flow Rate shoud be equal to Height x Width x Speed which calculates to be 8.39 cubic mm/sec.  Why the discrepancy?

Postato : 12/09/2023 10:38 pm
Condividi: