Latest Version Skipping Retract After Skirt?
 
Avisos
Vaciar todo

Latest Version Skipping Retract After Skirt?  

  RSS
Gwhite
(@gwhite)
Eminent Member
Latest Version Skipping Retract After Skirt?

I've been fighting print quality issues with Simplify3D, and figured I should see how PrusaSlicer works on this model.  I haven't used PS much, and when I opened the program, it noticed there was an update, so I installed that.  Step 1 was to run an extrusion multiplier calibration, with a single wall cube.  I don't recall running into this before, but every print has a fairly solid connection between the skirt and the model.  Here a picture:

PS-No-Retract-After-Skirt

I don't know if this is new behavior with 2.3.3, if there is a setting someplace I'm missing, or if this filament is just extra oozy.  It's hardly fatal, but it's a bit annoying...

Ideas/suggestions welcome.

Thanks!

Respondido : 09/08/2021 8:50 pm
kwerkshop
(@kwerkshop)
Miembro
RE: Latest Version Skipping Retract After Skirt?

I can confirm this is happening in 2.6.0 and has lead to failed prints for me, especially when there is a longer distance to travel after the skirt completes.

Respondido : 22/07/2023 6:05 am
Compartir: