Notifications
Clear all
is there an option to Swap Z height with position first layer only
is there away on the first layer only to swap the Z height command with position, so the nozzle is above the position where its going to start first then lower to z height?
instead of what is below.
;layer 1,
Z = 0.200
T0
G92 E0.0000
G1 E-0 F1800 ; custom retraction - A;
fan1;
G1 Z0.200 F1200
G1 X132.9280 Y147.7040 F8000
Napsal : 20/06/2024 10:03 pm