Installing PrusaSlicer to Raspberry Pi 4

Dernier message

RSS

3DPNano

(@3dpnano)

Active Member

Installing PrusaSlicer to Raspberry Pi 4

Hi,

I have been looking about different software's for 3D printing, in this case Stereolithography (DLP), and I think PrusaSlicer is the best one.

Can anyone please help me about how to install the software in a Raspberry Pi 4, and how to set it up. Do I need to check the compatibility with any of my components or it should be compatible with everything?

Thanks a lot!

Publié : 02/03/2021 10:53 am

Neophyl

(@neophyl)

Illustrious Member

RE: Installing PrusaSlicer to Raspberry Pi 4

https://forum.prusa3d.com/forum/prusaslicer/prusaslicer-2-3-0-on-raspberrypi-4-success/#post-350431

Publié : 02/03/2021 11:04 am

cryinkfly

(@cryinkfly)

Membre

RE:

I have written a guide/created an issue for the developers here!

Ce message a été modifié il y a 3 months par cryinkfly

Publié : 10/08/2024 8:29 pm

Statistiques du forum

559 Forums

63 K Sujets

443.5 K Messages

21 En-ligne

67.9 K Membres

Le dernier des messages: Prusa Core One - Intial thoughts...... Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé