Avisos
Vaciar todo
Infill extrusion multiplier by layer post-processing script
I have problem with infill over extrusion in smaller gaps. I have tuned E steps, did cube in vase mode for dimensional accuracy, all is ok, printer calibrated. But infill is still an over extruded in small gaps and it doesn't matter what brand of filament I use.
What do I need is post-processing script which seeks through gcode till it reaches ";AFTER_LAYER_CHANGE", if after that next line is ";0.8" it seeks for ";TYPE:Solid infill". If all these conditions are met it changes all E values until it reaches ";BEFORE_LAYER_CHANGE".
Can somebody help with script creation?
MK2.5S with OctoPrint.
Respondido : 10/11/2020 2:45 pm
RE: Infill extrusion multiplier by layer post-processing script
Did you solve this issue?
--------------------
Chuck H
3D Printer Review Blog
Respondido : 24/11/2020 12:20 am
Topic starter
answered:
RE: Infill extrusion multiplier by layer post-processing script
Did you solve this issue?
Nope.
Respondido : 24/11/2020 11:56 pm