Benachrichtigungen
Alles löschen
Infill 15% slices fine, change infill to 60% Prusaslicer dies a slow death....
Having Problems with PrusaSlicer. (File attached), on two different systems I can slice successfully at 15% infill, but if I increase infill from 15% to 60%, PrusaSlicer bogs down, then goes permanently non-responsive upon attempting to slice.
Using 2.3.2 -- Any Suggestions?
Dieses Thema wurde geändert Vor 3 years 2 mal von Hildow
Veröffentlicht : 01/09/2021 1:20 pm