Notifications
Clear all
I couldn't print this rose model
Hi everyone,
I tried to print this rose in this model.
However, when I printed out, it took me 14 hours to print on Ender 3 Pro V2 and the petals of the rose stick together. I tried to separate them but it breaks as showed in the picture below.
Could anybody help?
Thank you.
Huyan
Napsal : 21/02/2022 5:53 pm
RE: I couldn't print this rose model
"Sigh" 😔
The Filament Whisperer
Napsal : 22/02/2022 1:08 am
Robin se líbí
@swiss_cheese - I agree.
@huyan - Look up Vase Mode.
Cheerio,
Napsal : 22/02/2022 1:19 am
Swiss_Cheese se líbí
RE: I couldn't print this rose model
You need to print it in vase mode.
Napsal : 11/03/2022 4:23 pm
RE: I couldn't print this rose model
I third the "sigh" and add a "really?"
Napsal : 12/03/2022 4:20 pm
RE: I couldn't print this rose model
Vase mode in Prusaslicer...
Napsal : 13/03/2022 5:06 am