How to set a different Extrusion multiplier value at different layer height?

Dernier message

RSS

prusanewuser

(@prusanewuser)

Prominent Member

How to set a different Extrusion multiplier value at different layer height?

Hi, I am using PrusaSlicer-2.4.0-rc2. If I want the Extrusion Multiplier to be different at different layer heights, how do I do it? I went to Height Range Modifier but don't seem to find such option.

Publié : 19/12/2021 3:04 pm

Area51

(@area51)

Membre

RE: How to set a different Extrusion multiplier value at different layer height?

In the preview the "Add Custom G-code" can be used to change the extrusion multiplier at that level, g-code:

M221 S80

Will change change extrusion to 80% until changed again and:

M221 S100

Will set it to 100%.

Have a look at my models on Printables.com 😉

Publié : 20/12/2021 4:54 pm

prusanewuser et ont aimé

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

20 En-ligne

67.7 K Membres

Le dernier des messages: Ethernet slower than Wi-Fi? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé