GOO file format from Elegoo

Dernier message

RSS

Bret O

(@bret-o)

Active Member

GOO file format from Elegoo

Now that Elegoo has announced the opensource GOO File Format for their new printers is there any discussion of adding this in to PrusaSlicer to support these printers now? I really would rather just use PrusaSlicer for everything than having to do Chitubox/Lychee.

Publié : 09/06/2023 4:10 pm

(@mc-3)

Active Member

RE: GOO file format from Elegoo

I really want to know that too!

I'm using an mk4 and mk3s so i'm used to prusaslicer.
Up until now i use prusaslicer for supports and the like. And than i export the file and load it in chitubox.
I would love to just slice it in Prusaslicer and don't touch chitubox at all.

Publié : 28/10/2023 2:20 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

21 En-ligne

68.2 K Membres

Le dernier des messages: Prusa Slicer generating floating G-code for printing cones tips Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé