Notifications
Clear all
Firmware retraction not working
Hi, I have sudden issue with retraction. I have enabled firmware retraction, have set it correctly in Klipper for months but suddenly the G10/G11 is not being added into the Gcode, therefore no retraction is taking place.
PS 2.6 on Mac. G-code flavor is set to Marlin.
When I try the same model and similar settings with SuperSlicer, G10 and G11 are there.
Any ideas? Thanks!
This topic was modified 1 year ago 2 times by Jiří Fiala
Posted : 09/08/2023 9:02 pm
Topic starter
answered:
RE: Firmware retraction not working
Sorry I meant the gcode flavor is set to KLIPPER, not Marlin. I can't edit the OP anymore.
Posted : 09/08/2023 9:09 pm