Notifications
Clear all
Fan speed not applied to overhang
Hi,
I have some issue with the Bridges fan speed option. The popup says "fan speed applied to bridges and overhangs" but the fan speed is not applied to overhangs only to fully unsupported bridges. It simply ignores overhangs, I cannot get it to work. Any material that prints hotter than average like ABS needs this option to work else it is not possible to print it properly. Blasting the fan continuously results in bad layer adhesion. Version 2.5.0
Opublikowany : 19/02/2023 2:20 pm
RE: Fan speed not applied to overhang
have the same issue on version 2.7.1 -- bridges are fine, overhangs look awful
Opublikowany : 18/02/2024 9:09 pm