Enabling BLTouch in PrusaSlicer 2.4.2 for Creality CR-10 v3
 
Notifications
Clear all

Enabling BLTouch in PrusaSlicer 2.4.2 for Creality CR-10 v3  

  RSS
gcarmich
(@gcarmich)
Active Member
Enabling BLTouch in PrusaSlicer 2.4.2 for Creality CR-10 v3

I have a Creality CR-10 v3 printer which is supported by the PrusaSlicer.  My Creality printer has a BLTouch installed for bed leveling.  How can I enable the BLTouch in PrusaSlicer so that it bed levels automatically before every print?

Thank you,

Gil

Best Answer by Robin:

What’s in your printer profile‘s start gcode field?

You need a G29 to start the levelling routine preferably after the bed has been heated. This only works, if the levelling feature has been activated and configured in the printer‘s firmware of course.

Posted : 31/05/2022 2:33 pm
Robin
(@robin)
Noble Member
RE: Enabling BLTouch in PrusaSlicer 2.4.2 for Creality CR-10 v3

What’s in your printer profile‘s start gcode field?

You need a G29 to start the levelling routine preferably after the bed has been heated. This only works, if the levelling feature has been activated and configured in the printer‘s firmware of course.

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Posted : 01/06/2022 8:18 am
gcarmich
(@gcarmich)
Active Member
Topic starter answered:
RE: Enabling BLTouch in PrusaSlicer 2.4.2 for Creality CR-10 v3

Success!  Thank you!

Posted : 07/06/2022 4:22 pm
Robin liked
Share: