Does PrusaSlicer have an equivalent for cura's moveinside setting?
 
Notifications
Clear all

[Résolu] Does PrusaSlicer have an equivalent for cura's moveinside setting?  

  RSS
BoguesUser
(@boguesuser)
Active Member
Does PrusaSlicer have an equivalent for cura's moveinside setting?

Does PrusaSlicer have an equivalent for cura's "moveinside" setting?

It can be seen here in action. It is enabled when combing is turned on.

Best Answer by Asraff Amzani:

I believe what you're looking for is actually printer settings > extruder > wipe while retracting and/or lift-z and/or retract on layer change

Publié : 01/12/2022 4:11 am
Asraff Amzani
(@asraff-amzani)
Estimable Member
RE: Does PrusaSlicer have an equivalent for cura's moveinside setting?

I believe what you're looking for is actually printer settings > extruder > wipe while retracting and/or lift-z and/or retract on layer change

Publié : 04/12/2022 4:20 pm
BoguesUser
(@boguesuser)
Active Member
Topic starter answered:
RE: Does PrusaSlicer have an equivalent for cura's moveinside setting?

Looks like you are right. Unfortunately, there aren't that many controls for wipe.

Super Slicer has controls for it so I'll probably move to that.

Thank you for the help.

Publié : 04/12/2022 6:31 pm
Partager :