Different infill on part
Hello,
I would like to ask if it´s possible to easily set different infill on some area of a part? For example I will print sphere by 20% infill, but i would like to have center of the sphere with 100% infill.
Thank you
RE: Different infill on part
Yes. Add a spherical modifier and set it to 100 percent infill
Regards Joan.
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Different infill on part
Thank you
RE: Different infill on part
you may be wise to print the sphere in two pieces and glue them together, supports on a sphere are likely to cause artefacts on the lower surface
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK