Custom gcode on the slicer?
so pretty much I wanna know if you can do custom gcode on the slicer like you can addons with Cura. only reason is since I can't afford a pi for octolapse so this is my next best bet for showing and monitoring prints. i wanna know if you can do something like this video says at around 8:10 ( ) in prusaslicer for timelapses. i dont really see an area that you can do it so im asking here. if you don't watch the video which is fine as its lengthy, its pretty much the hotend moving and hitting a bluetooth shutter button to a phone thats set up generally, then resumes printing after every layer. if there already is a thread on this, sorry, I couldn't find it anywhere, and yeah thats about it
Best Answer by JoanTabb:
In expert mode, a something like :-
G1 X234 Y205 F3600
to set the preferred X and Y positions and the preferred feed rate to get there.
you could also set a delay, if you needed it, for the camera to execute the photo.
Regards Joan
RE: Custom gcode on the slicer?
In expert mode, a something like :-
G1 X234 Y205 F3600
to set the preferred X and Y positions and the preferred feed rate to get there.
you could also set a delay, if you needed it, for the camera to execute the photo.
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Custom gcode on the slicer?
exactly what I was looking for, and it does work! thanks a lot!
RE: Custom gcode on the slicer?
My Pleasure.
from what I think I heard in the video, it seems simpler than the cura option too.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK