Creality CR-10-V3 Print quality issues - Prusa Slicer
 
Notifications
Clear all

Creality CR-10-V3 Print quality issues - Prusa Slicer  

  RSS
gcarmich
(@gcarmich)
Active Member
Creality CR-10-V3 Print quality issues - Prusa Slicer

I have a Creality CR-10 V3 printer in addition to my original Prusa MK3S+.  I bought the Creality to do prints too large for my Prusa.

The Creality printer has been very hard to work with to get good 3D print - especially compared to the Prusa.  I switched to the Prusa Slicer and the Creality prints are better but still not great.  Main problems are layer adhesion (both to the build surface and to other layers), surface finish, and support break away.

I rarely use my Creality because of these issues.  I have modified the print setting for the Creality to as closely mimic the Prusa setting as I can but there are still issues.

Has anyone encountered these issues with Creality printers?  I have enquired with Creality but they have not offered any fixes.

 

Thanks,

Gil

Opublikowany : 14/12/2022 5:10 pm
Share: