Cannot Enter Custom Gcode in Prusaslicer 2.2.0

Dernier message

RSS

dkaustin

(@dkaustin)

Active Member

Cannot Enter Custom Gcode in Prusaslicer 2.2.0

Just upgraded to Prusaslicer 2.2.0 and there is no option to enter custom start and finish gcodes. I have uninstalled and reinstalled, no change.

Any ideas, anyone?

Publié : 29/05/2020 4:40 pm

JoanTabb

(@joantabb)

Veteran Member Moderator

RE: Cannot Enter Custom Gcode in Prusaslicer 2.2.0

Have you chosen Expert mode?

Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Publié : 29/05/2020 5:08 pm

bobstro

(@bobstro)

Illustrious Member

RE: Cannot Enter Custom Gcode in Prusaslicer 2.2.0

Here's the custom gcode screen:

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Publié : 29/05/2020 5:24 pm

Statistiques du forum

565 Forums

63.8 K Sujets

447.6 K Messages

21 En-ligne

69.5 K Membres

Le dernier des messages: How do I set the GCODE macros to not raise the printhead so much? Notre nouveau membre: SilenceDIY Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé