Notifications
Clear all
better raft to first perimter connection in single wall prints
Hi,
im almost exclusivly printing vasemode and im having an issue where the contact between the raft and the perimeter feels a bit weak, especially on large prints.
Usually my prints look like this where i expanded the raft a bit and set the gap to 0.
however when i print tall models they sometimes rip from the raft (but not from the bed).
I tried setting the gap distance to -0,2 to smoosh the first primimeter deeper into the raft, but negative gaps arent allowed.
any ideas how I could increase the contact surface between raft and first layer?
cheers f.
Posted : 20/02/2023 11:39 am