RE: Avoid solid infill near sloping walls
Have I been raised to Goddess status?
the lower cone has no infill, near the walls whilst the upper cone does have infill!
the lower cone has a modifier block with zero top layers
Oddly my powers faded out about 28mm from the bottom...
But it's an improvement!
Be gentle with me, I have only had goddess status for a couple of minutes 🙂
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Avoid solid infill near sloping walls
Unfortunately no, this bug which has been around for half a decade has yet to be addressed by the development team. It's tough halfway decent developers are hard to find, ones that actually care about making a good product are even rarer. With the rise of better cheaper alternatives to Prusa Printers its likely that open source contributors won't step in either. Prusa has been coasting for so long its really sad to see such a brand you really loved just not give a
https://github.com/prusa3d/PrusaSlicer/issues/9245#issue-1478250727