Anycubic Kobra GO - Profile
Hi, does anyone here have an Anycubic Kobra Go?
What profile are you using with the stock setup? Any suggestions?
I know that there is an Anycubic Kobra thread, but the go is a little different.
Thanks in advance 🙂
RE: Anycubic Kobra GO - Profile
Hi the latest Kobra GO firmware (1.3.4) uses Mariln 2 bugfix-2.0.x, so create a custom profile and enter:
Firmware: Marlin 2
x: 222
y: 222
beginning: 0, 0
I am currently printing my first model sliced with these settings and so far so good.
RE: Anycubic Kobra GO - Profile
And leave all other settings?
RE: Anycubic Kobra GO - Profile
Yup. Works for me perfectly fine.
RE: Anycubic Kobra GO - Profile
hello someone have a profile for anycubic kobra go
RE: Anycubic Kobra GO - Profile
I made a Prusa Slicer profile for the Anycubic Kobra Go. I have made it combining aspects from the profiles of both the Prusa i3 MK3S+ and the Ender 3V2 and also elements from the cura settings I use. Do you know where I should upload it?
RE: Anycubic Kobra GO - Profile
Can you send me your profile to e-mail?
RE: Anycubic Kobra GO - Profile
Can you send it to me as well?
RE: Anycubic Kobra GO - Profile
You might offer it on the prusa slicer Github for consideration of inclusion in prusa slicer in the future!
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Anycubic Kobra GO - Profile
Here is a link to my google drive where i have the Prusa Slicer profile I daily drive. Sorry for the late response, I only now recieved notifiactions regarding this post.
https://drive.google.com/drive/folders/1fKjK-cYmaFWGWx15S3N300Hh_dBsE5dR?usp=sharing