Adjusting fan speed
I have a MK2S and am running into thermal runaway issues with my hotend. I found that tuning the fan speed from 255 to 200 in the beginning of the print solves this issue. How do i make this change in Slic3r? I have not seen a setting for cooling.
Best Answer by 3Delight:
Make sure you have PrusaSlicer set to Expert mode (top right) then the settings will show up. (See the relevant PrusaSlicer Guide page about the mode settings here: https://help.prusa3d.com/en/article/simple-advanced-expert-modes_1765 )
The relevant PrusaSlicer Guide page about the cooling settings is here: https://help.prusa3d.com/en/article/cooling_127569
Google reveals:
https://manual.slic3r.org/expert-mode/cooling
I hope this helps.
--------------------
Chuck H
3D Printer Review Blog
Prusaslicer
Hey thanks for the link. I found this as well but it seems that PrusaSlicer 2.2.0 doesnt have this setting listed.
RE: Expert mode required...
Make sure you have PrusaSlicer set to Expert mode (top right) then the settings will show up. (See the relevant PrusaSlicer Guide page about the mode settings here: https://help.prusa3d.com/en/article/simple-advanced-expert-modes_1765 )
The relevant PrusaSlicer Guide page about the cooling settings is here: https://help.prusa3d.com/en/article/cooling_127569
Perfect!
That was it, thank you!!