2.8.1 still doesn't show time remaining to filament change once a print starts

Last Post

RSS

CWCDesigns

(@cwcdesigns)

Active Member

2.8.1 still doesn't show time remaining to filament change once a print starts

I do a crap ton of filament changes on the designs I make on my small MK3s+ farm and once 2.8 was released the time remaining until the next filament change was removed. Now I either have to fully guess or write them down on a post it and use a stop watch. Which is horribly inefficient if I have to leave the room or do something in the meantime. Was this an intentional removal or just a bug that hasn't been addressed?

This topic was modified 2 months ago by CWCDesigns

Posted : 18/09/2024 10:46 pm

_KaszpiR_

(@_kaszpir_)

Honorable Member

RE:

Do you mean in PrusaSlicer or in the firmware on the printer screen?

See my GitHub and printables.com for some 3d stuff that you may like.

Posted : 19/09/2024 8:00 am

Neophyl

(@neophyl)

Illustrious Member

RE: 2.8.1 still doesn't show time remaining to filament change once a print starts

Its been reported as a bug previously and has a number on Github. It has not been marked as fixed yet or mentioned in the release notes of 2.8.1-rc1. So there is no reason to have expected it to have been fixed in this version.