Notifiche
Cancella tutti
micro blobs on outer wall of wheel print - where to start?
I have a model that I've been printing flawlessly on my CR10sPRO for months. Due to some machine maintenance, I'm trying to print the same model on my CR6SE, but getting small, micro blobs on the sides. The model is basically a cogged wheel as shown below.
I've attached the .3mf file for further reference.
Seems like a retraction issue, but not sure. Any suggestions? The model is already set up to paint the seam in one of the cog indents.
Questa discussione è stata modificata 2 years fa 2 tempo da Webdad
Postato : 14/10/2022 6:40 pm
Topic starter
answered:
RE: micro blobs on outer wall of wheel print - where to start?
Not sure what the deal is but the file isn't showing up.
Here is a link: Wheel 3mf
Postato : 14/10/2022 6:47 pm