rattling during printing

Dernier message

RSS

Bezbolestný Pe...

(@bezbolestny-pekac)

Membre

rattling during printing

Hello. I've been using the new Core One L for two weeks now. Can anyone please advise me on what might be causing this awful rattling noise?

Ce sujet a été modifié il y a 2 weeks par Bezbolestný Pekáč

Publié : 02/01/2026 6:06 pm

Ruebarb

(@ruebarb)

Trusted Member

RE: rattling during printing

https://forum.prusa3d.com/forum/prusa-core-one-l-hardware-firmware-and-software-help/metallic-rattling-while-printing

Posted by: @bezbolestny-pekac

Hello. I've been using the new Core One L for two weeks now. Can anyone please advise me on what might be causing this awful rattling noise?

Publié : 02/01/2026 10:07 pm

SweGear

(@swegear)

Membre

RE: rattling during printing

Had some rattling and found that the door was flapping against bottom frame, bar the display is mounted too. Adjusted the door and now no rattle..

Publié : 07/01/2026 1:05 pm

Rui Cook

(@rui-cook)

Eminent Member

RE: rattling during printing

Have you figured it out?

Posted by: @bezbolestny-pekac

Hello. I've been using the new Core One L for two weeks now. Can anyone please advise me on what might be causing this awful rattling noise?

Have you figured it out?

Publié : 14/01/2026 7:32 pm

Statistiques du forum

595 Forums

70 K Sujets

490.1 K Messages

15 En-ligne

80.9 K Membres

Le dernier des messages: i3 Origional firmware upgrade failed Notre nouveau membre: SocialMisanthrope Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé