Notifications
Clear all
Not able to change filament after running out
Whats the point of the filament sensor close to the filament spool when I'm not able to get hold of the filament after running out?
I'm on my 4th roll now. None of the two first rolls could ram the filament so I could grab it after running out.
What am I doing wrong or should this not work?
Posted : 05/04/2026 9:49 am
1 people liked
RE: Not able to change filament after running out
I have had this happen a couple of times as well. Only on the very first time, did it work so I could pull the short end out.
Posted : 06/05/2026 11:27 pm