Notifications
Clear all
very ugly si
I don't know how to translate this in English but I had some serious flaws in my prints this afternoon. This morning no problems. Same filament (sunlu black pla), same generic settings. It happened in the horizontal plane. Is this a partial clog? My filament runs without restriction and was dried before.
As a noob I would value your views.
Publié : 08/07/2025 6:39 pm
By the look of it the filament absorbed moisture whilst exposed during the morning's printing. Is your climate very humid?
Dry it and retry.
Cheerio,
Publié : 08/07/2025 11:04 pm
Topic starter
answered:
RE:
@Diem, Moisture is indeed around 60%, I will dry the filament, thanks for the diagnose.
Publié : 09/07/2025 4:50 am