Notifiche
Cancella tutti
Gaps on top layer, underextrusion, slicer issue or wrong parameters?
Hey, I've got this problem pictured here:
Here a little exaggerated, because the filament color change was just one layer above the magenta one. But there's gaps where the edges meet the cutouts. How can I fill those? I even sort of see them in slicer when zoomed in:
I've tried upping the infill overlap settings from 15% to 20% but I don't see much difference. Filament is Made for Prusa PLA+ Matt
Thanks!
Questa discussione è stata modificata 3 weeks fa da Maciej Janowski
Postato : 09/05/2025 10:48 pm
RE: Gaps on top layer, underextrusion, slicer issue or wrong parameters?
Have you tried both arachne and classic for the perimeter generator? looks a bit like general under extrusion though
Postato : 12/05/2025 9:54 am
tomtim hanno apprezzato