Notifications
Clear all
ASA post print wrinkles?
I started my new Core One on PLA, which was great. Fast too.
I stepped up to ASA (fresh spool) for some outdoor prints. The prints look great while they are in the printer (and low light). When I get the ASA cooled off and out of the printer, it looks a little shriveled. It's funny and sad at the same time. It's not terrible, but I'm wondering if I should be increasing or decreasing my 4 wall thickness (0.4mm HF nozzle), or 15% grid infill. Maybe not the default 40 C chamber temp?
It waits until it cools off to shrink up at least. It's a 10 hr print.
I wanted to put this under the printing section. Is that not up to me on this forum?
Posted : 19/06/2025 12:00 am