Notifications
Clear all
Z axis calibration required after prints
Anyone experiencing this? After a few prints the print bed will bind when trying to raise it back up to start the next print. I need to reset the printer to get it to stop, and then recalibrate Z axis. After that it will print fine for 3-10 prints then require the calibration again.
Posted : 09/03/2025 7:52 pm
RE: Z axis calibration required after prints
Have you made sure the rods are greased? There have been a few people saying their rods weren't lubricated from the factory.
Posted : 10/03/2025 5:42 am
Topic starter
answered:
RE: Z axis calibration required after prints
Ya they are greased... I will get a few more hours in and then do a tune up and see if that helps.
Posted : 10/03/2025 7:15 pm