Notifications
Clear all
Puppy Error, x-Buddy extension not resbonding
Hello everyone,
I just finished my assembly and got this lovely error message:
Puppy error, x-buddy extension not resbonding
->prusa.io/31514
-I opened the X-Buddy cover
-I checked the jumper connection between the boards
-I messured the Voltage of the power cables
-I tried getting more infomation on prusa.io
-Neither of the boards get hot or anything
Does anyone know how to solve this? Tanks in advance
Posted : 26/07/2025 2:49 pm
RE: Puppy Error, x-Buddy extension not resbonding
Is the red wire attached to the side of the jumper cable that is connected to the buddy extension board?
Posted : 26/07/2025 11:56 pm
RE: Puppy Error, x-Buddy extension not resbonding
Hallo, hast schon nachgesehen der Stecker mit dem ROTEN DRAHT sollte oben gesteckt sein.
Posted : 28/07/2025 12:57 pm
RE: Puppy Error, x-Buddy extension not resbonding
Thanks, that was my issue, the photo wasn't clear. But the instructions were...oh well! Thanks
Posted : 09/09/2025 2:00 pm