Notifications
Clear all
Has anyone modified the core one firmware to allow 60c chamber temps as before?
As in the title, I would like to have a 60c chamber again as the current new hard limit of 55c is causing print failures during engineering prints.
at 55c the chamber vent fans now kick on at 100% and this causes a large cold air draft which leads to warping and layer shift in the case of long prints.
I believe 6.4.0 was the last update before they downgraded the chamber temps, but I wanted to ask first in case anyone has edited one of the latest to keep the QoL updates but not apply the new chamber temperature limit
Thank you!
Posted : 05/06/2026 11:11 pm