Core One + Hotend Fan fail

Dernier message

RSS

Meihswei

(@meihswei)

Membre

Core One + Hotend Fan fail

I recently had my Core One notify me of the Hotend fan RPM test fail during a print. I dusted, cleaned, and made sure the connection to the Nextuder LoveBoard was good but it still failed. No problem I thought and ordered two new fans (have a spare on hand just in case) through PRUSA. I just got the new fan installed and it is still failing. Could this be an error with the LoveBoard?

Any help is greatly appretiated!

Publié : 28/04/2026 1:40 am

hyiger

(@hyiger)

Famed Member

RE: Core One + Hotend Fan fail

Posted by: @meihswei

Could this be an error with the LoveBoard?

Maybe. However at this point it's best to contact Prusa support over chat.

Publié : 28/04/2026 1:58 pm

Statistiques du forum

598 Forums

71.4 K Sujets

501.4 K Messages

12 En-ligne

82.4 K Membres

Le dernier des messages: Filament grinding. Notre nouveau membre: Tim Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé