Closing Idler Block

Ultimi post

RSS

Andrew Mercer

(@andrew-mercer)

Utenti

Closing Idler Block

I'm new to 3D printing. I opened the idler block (shown on the left below) to fix stuck filament. I tried closing it with force but didn't get close and felt like I was going to break it. What would be the best way at closing it?

Postato : 11/12/2025 4:23 am

Statistiche Forum

595 Forum

69.4 K Discussioni

486 K Post

17 Online

79.2 K Utenti

Post recenti: Slicer hängt, g-Code wird scheinbar dennoch generiert Ultimo utente registrato: João de Brito Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso