Notifications
Clear all
Camera jammed the print board
The buddy camera fell during a print and caused the board to jam into it getting stuck while it was lifting. I got the buddy camera out but now the print board will not move up or down when initiating a print to test the sensor. It will move up and down smoothly to change filament. However when preparing for a print it just hums and stays idle at the mid height position. I have no idea what to do. Any help would be so much appreciated.
Publié : 18/09/2025 10:55 pm
RE: Camera jammed the print board
Try a control/calibration/z-alignment?
Publié : 19/09/2025 5:19 pm
RE: Camera jammed the print board
Wanted to add here that the Buddy camera magnets suck. I've had that happen to me so now it's stuck on with double-sided tape.
Publié : 19/09/2025 5:39 pm