XL and Core Belt. Are they the same??
Does anyone know if the belts used on the XL are the same as used on the Core One, except for length? I would like to use the XL belts on a Core One for easier installation then trim to length.
RE: XL and Core Belt. Are they the same??
Does anyone know if the belts used on the XL are the same as used on the Core One, except for length? I would like to use the XL belts on a Core One for easier installation then trim to length.
They are the same (2GT belts, 6mm wide, 2mm teeth), but then my question would be why? Are you having a problem with your existing belts? If you are finding that the provided belts are "too short" then you are probably doing something wrong with the routing.
RE: XL and Core Belt. Are they the same??
It is more about my hands. I have big and arthritic hands. I fumbled with the short exposed teeth a lot, and it is frustrating and time-consuming. I don't mind paying for longer OG belts then trimming them. I spent hours getting the originals installed, and by the time I had them working, my hands were sore. I resorted to purchasing a roll of GT2 that looks the same, but I am having a layer shift on large, wide prints and cannot get the Y-axis to pass, so I am going to replace the belt material I purchased with some OG Prusa belts for the XL just to see if that is my problem.
THX for help.